Reuben's Home Inspection Blog

head_left_image

Don’t Poke Holes In Your Pipes

Most ice makers and whole house humidifiers that I see have a saddle valve supplying the water. These are devices that allow for a very fast, cheap, do-it-yourself installation of a ¼” water supply line.

Saddle valves are installed by tightening a metal clamp on to a water pipe, then tightening down a needle valve until it pierces the water pipe.  No cutting of pipes is required, no soldering, no special tools… simple.  Very DIY.  The needle just pokes a hole in the pipe, and it can even be done without even turning off the water (but I sure wouldn't recommend it).  There has to be a catch, right?

Saddle Valve

There is.  They leak, and saddle valves are prohibited by the Minnesota State Plumbing Code.

 

Leaking Saddle Valve
Leaking Saddle Valve

 

Most of them don’t leak, but they have a much higher chance of leaking than a properly installed water valve.  If they do end up leaking, the repair will involve doing all the stuff that you’re supposed to be able to avoid – cutting, soldering, etc.

My advice is to not use saddle valves.  If you’re installing an appliance that needs a ¼” water pipe, have a proper shutoff valve installed.  It will certainly take more time, but you'll dramatically lower the chances of it leaking.

 

Proper Shutoff Valve
Proper Valve

 

If you already have one in your house, try to leave it alone.  Every time you operate the valve, you’re increasing your chances of creating a leak.

Reuben Saltzman, Structure Tech Home Inspections

        

Comment balloon 9 commentsReuben Saltzman • May 25 2010 06:09AM
Don’t Poke Holes In Your Pipes
share
Most ice makers and whole house humidifiers that I see have a saddle valve supplying the water. These are devices that allow for a very fast, cheap, do-it-yourself installation of a ¼” water supply line. Saddle valves are installed… more
Peeling Paint On Redwood Siding: What To Do?
share
I've seen it happen at countless houses, and now it's happened to me… my paint is peeling (again). I have a Minneapolis home that was built in 1939 with redwood siding, and I can't get the paint to stay on. I've tried almost.. more
My Beef With One-And-One-Half Story Houses
share
I've lived in a one-and-one-half story house in Minneapolis for the last six years, and I feel like I've earned the right to complain about them. My main beef with them is insulation and ventilation; they're a pain in the butt and they… more
Four Common Water Heater Installation Defects
share
Gas water heaters are a lot like decks, in the sense that most handymen feel qualified to install one. Thanks to these handymen, I find more installation defects on these two items than just about any other component in the home, and… more
The Most Common Repair for Boilers in Minneapolis
share
While boilers aren't commonly used for new homes in Minnesota, there are still plenty of houses in Minneapolis and Saint Paul that rely on boilers for heat. I'm a big fan of boilers - so much so that I even wrote a blog about why I like… more
The Problem With Hand Showers
share
Hand showers are usually installed improperly - I estimate that at least 95% of the hand showers that I inspect have the same installation defect. Looking at the photo below, can you guess what it is? If you said outdated… more
Dryer Transition Ducts: Is Foil Better Than Semi-Rigid Aluminum?
share
I've always told my Minnesota home inspection clients that the best type of dryer duct material is a completely rigid metal duct, with as short of a run as possible. I've recommended using semi-rigid metal when necessary, as a way of… more
Corrugated Stainless Steel Tubing (CSST) - The New Gas Line
share
Several months ago I wrote a blog about how great PEX tubing is and today I'm going to discuss the equivalent for gas piping - Corrugated Stainless Steel Tubing, which is commonly referred to as CSST. This is a product that can be… more
It's Not A Gas Line, It's A Gas Connector
share
Two weeks ago I wrote a blog about the most common places to find gas leaks and I said I'd follow up with a blog about gas connectors - those short, flexible, corrugated things that are used to connect gas appliances to gas piping… more
Wet Basement? Don't Call A Specialist Just Yet.
share
As I took a walk through my neighborhood last weekend, I noticed that a lot of houses in my neighborhood have sump pumps, because they kept discharging water. We've had a rapid snow melt here in Minnesota, and that means saturated… more