Reuben's Home Inspection Blog


Don't Let Your Home Get Flooded; Replace Those Old Rubber Hoses

Burst washing machine hoses have to be one of the most common causes of catastrophic water damage in homes.  When I find rubber hoses used to connect the washing machine, I often mention to my clients that it's a good idea to replace them.  It's downright disturbing how often my client then goes on to share a story with me about how they already had a flooded house or knew someone who's house flooded because of a failed washing machine hose.

Old Washing Machine HosesWhen I was about ten years old, one of our rubber washing machine hoses burst while we were gone for a few hours.  We arrived home to find an inch of standing water in our fully finished basement.  That was one heck of a mess.

Every time a washing machine shuts off the water, a shockwave is sent through the water pipes - remember my blog about water hammer? While installing a water hammer arrestor at the valve will protect the pipes downstream from the valve, this does nothing to protect the rubber hoses between the valve and the washing machine from water hammer. The video clip below, courtesy of Sioux Chief, gives a great demonstration of what happens to the washing machine hoses every time the water is suddenly turned off.  The text in this video mentions plastic pipes, but the effect would obviously be much greater with rubber hoses.

As rubber ages, it loses it's flexibility.  After being subjected to water hammer over and over for many years, the rubber washing machine hose is eventually going to fail, and it's going to be one heck of a mess.  Here are a few suggestions to lower the risk of your washing machine hoses suddenly bursting.

Turn off the water supply when not in use

Washing machine manufacturers actually tell you to do this in their installation instructions.  The text below comes directly from a Maytag washing machine user manual.

Warning from Maytag washing machine user manual

I can tell you from experience that it's extremely rare for anyone to actually do this.

Replace your old rubber hoses regularly

I've heard that a good rule of thumb is to replace rubber washing machine hoses every five years.  That sounds good, but how do you remember?  Another tip I've heard is to replace your washing machine hoses every leap year.  Not a bad idea.

Install an emergency shutoff kit

You can purchase an emergency shutoff kit, such as the type sold by Floodstop, which will almost surely prevent any type of catastrophic leak.  These devices come with a water sensor, so if a leak is detected, an alarm goes off and the water supply valves automatically close.  These kits are battery powered, and according to the web site, can be installed in about 10 minutes.  Not a bad idea.

Install stainless steel braided hoses

This is the simple advice that I usually give during home inspections.  Stainless steel braided hoses are much more resistant to bursting, and they're fairly inexpensive.  You can buy a pair on Amazon for under $17.

Stainless Steel Washing Machine Hoses

There's a new version of these hoses called Floodsafe®, which is supposed to completely shut off the water supply in the event of a burst hose.  I did a little testing with these hoses, and I'm not a big fan.  I'll post a follow-up on this topic next week.

In the meantime, do yourself a favor and pick up some new washing machine supply hoses.  On a project difficulty scale of one to five, replacing your washing machine hoses falls somewhere between zero and one.  If you can connect a garden hose to a faucet, you can replace your washing machine hoses.  Just use a wrench to loosen the old hoses, and give the new hoses an extra 1/4 turn with a wrench after you have them hand-tightened.

Reuben Saltzman, Structure Tech Home Inspections


Comment balloon 52 commentsReuben Saltzman • July 24 2012 03:22AM
Don't Let Your Home Get Flooded; Replace Those Old Rubber Hoses
Burst washing machine hoses have to be one of the most common causes of catastrophic water damage in homes. When I find rubber hoses used to connect the washing machine, I often mention to my clients that it's a good idea to replace them. It's… more
Storm chasers and defective roof installations
Have you ever noticed roofs with shingles popping up all over the place? A common reason for this is the use of nails that are too short. When there are popped nails all over the roof, it might be the sign of a defective roof installation;… more
Observe and Report? That's for Mall Cops, not Home Inspectors
While reading a blog post from a good home inspector (a guy I've gotten to know and respect over the years), I discovered an interesting difference between home inspection Standards of Practice (SOP) - specifically, between the ASHI and InterNACHI… more
Dirty glass at gas fireplaces
Originally posted at: http://www. structuretech1. com/2012/07/dirty-glass-at-gas-fireplace After years of use, gas fireplaces often develop a cloudy white haze on the glass. This white haze makes the flames difficult to see, ruins any… more
What causes banging water pipes?
Originally posted at: http://www. structuretech1. com/2012/06/water-hammer/ Have you ever heard a banging noise coming from your water pipes when the water is turned off quickly? It usually sounds like the pipes are banging on something inside… more
A Primer on "S" Traps
A common plumbing defect found in many older houses is an "S" trap. An "S" trap is named so because it looks like an "S" on its side - it basically consists of a normal trap, and then another trap installed right up… more
Hot Water At My Kitchen Sink 450% Faster
Do you ever get annoyed with how long it takes to get hot water at your kitchen sink? I do did, up until last weekend. It used to take a full 45 seconds with the hot water turned on full blast before I would actually get hot water my kitchen… more
Deck Inspections: Check The Guardrails
The CPSC estimates that between 2003 and 2007, there have been over eleven thousand injuries caused by structural failure or collapse of guardrails at outdoor decks. It's not tough to understand why - when people have parties in the summer,… more
Deck Inspections: Is Your Deck Properly Attached To The Building?
May is National Deck Safety Month, so I'm going to start off this month by writing about the most common cause of deck collapses - improper attachment to a building. Most decks are supported on one side by the building, and on the opposite side by… more
Improper Shingle Nailing = Defective Roof Installation
One of the most common defects I find with asphalt shingles is improper nailing. The manufacturers of asphalt shingles give specific instructions on how to fasten shingles, and they're all pretty much the same. Unfortunately, following those… more